ZP-5/7/9 Rotary Press
Operating methods of electrical appliances
1. Console Operating Panel:
2. Operating steps: Open the electric box door, close the power switch, light the indicator on the operation panel, press "run" key, slowly rotate the frequency conversion knob, the speed will be added slowly. If you need to stop urgently, press "stop" key, the tablet press will stop running immediately. After pressing, open the box door and cut off the power supply.
Common failures and troubleshooting methods
360彩票注册网址 1. Upper and lower pressure wheels and shafts alternate: oil breakage and wear of pressure wheels and shafts, slight wear and tear, refueling after repair. Serious wear and tear. Replace immediately.
2. Wear on track:
2.1 Dry grinding caused by oil breakage causes slight damage to track surface, which should be repaired in time and replaced seriously.
2.2 The lubrication between the track and the punch rod with poor oil quality can only be selected by oil lubrication, and 30 # gear oil or air compressor oil can be selected. Brush is applied once before starting the machine.
360彩票注册网址 2.3 If there is too much dust, the suspension impact will occur, which will lead to rail wear, the granulation process should be changed to ensure that the powder content of particles (more than 100 meshes) does not exceed 10%.
3. The difference of film weight exceeded the standard.
360彩票注册网址 3.1 The feeder is worn out or incorrectly installed. Please change the wear of the feeder. If the installation is inappropriate, adjust it in time.
3.2 Die problems, check the total length of the upper and lower punch rods, if beyond the tolerance range, then stop using.